Stacked washer and dryer tower fitted into a laundry closet

LG

LG Appliance Repair in San Jose, CA

Read us the LG code and the model. The tech tests the part the code points to, and you see the written price before it's replaced.

Mainstream brand

LG

  • French Door Refrigerators
  • Kimchi Refrigerators
  • WashTower
  • Front-Load Washers
  • Dishwashers
  • Electric Ranges

On an LG, the long coverage terms attach to specific parts. That makes the first step on every LG visit finding out exactly which part failed. San Jose Appliance Care handles LG appliance repair in San Jose for French door and Kimchi refrigerators, front-load and top-load washers, the WashTower, dryers and electric ranges. Read us the code from the display along with the model number, and a registered, insured appliance tech diagnoses it at your address. Calls from San Jose, Sunnyvale, Milpitas, Fremont and the towns between them are all covered.

LG fridge not cooling: Er FF, Er rF, Er CF and other door codes

An LG refrigerator puts its faults on the door display. Depending on the model, the same code can read Er FF, E FF or just F, and each one points at a separate part of the fridge.

French-door refrigerator with its right-hand door standing open

Er FF says ice or frost has jammed the freezer fan motor. Ice in that spot is a defrost symptom. The tech tests the defrost heater, the defrost sensor and the fan motor. LG counts a code that returns once the ice has melted as a job for a tech.

Er CO (or E CO) means the main control board and the display board have lost contact. LG puts it down to either board or a loose wire, and says it has to be checked in the home.

Er IF belongs to the ice maker fan, which pushes freezer air over to the ice maker. When an LG showing that code starts making less ice, the fan and its wiring are tested before the ice maker gets touched.

Er rF is the fan that moves cold air through the fresh-food side, and LG ties it to frost too. LG’s own fix for frost is a full defrost with the fridge unplugged, which takes about a day in summer and up to three in winter, and a code that returns afterward needs the tech.

Er CF is the condenser fan at the bottom back, which pushes heat off the condenser; LG puts it down to the fan motor, a loose wire or the main board.

Er FS or Er rS means the freezer or fridge temperature sensor has shorted or come unplugged, and LG gives no owner step for either.

On an InstaView, the glass panel lights up when you knock twice. If the inside lights stay dark, LG has an LED lamp checked by a tech rather than swapped by the owner, and the door switch and wiring come next.

Kimchi refrigerators use a code list of their own, so tell us it’s a Kimchi model. A warm LG with no code showing is covered under refrigerator and freezer repair, and slow or missing ice on any make is on the ice maker repair page.

Which LG parts stay covered after year one

These terms come from LG’s U.S. warranty documents for refrigerators and front-load washers.

Part Term Coverage
Refrigerator internal and functional parts Year 1 Parts and labor
Sealed system (condenser, dryer, connecting tube, evaporator) and compressor Years 1 to 5 Parts and labor
Linear or inverter compressor Years 6 to 10 Part only
Washer internal and functional parts Year 1 Parts and labor
Washer direct drive motor (stator or rotor) Years 1 to 10 Part, plus labor in year 1
Washer stainless steel drum Years 1 to 3 Part, plus labor in year 1

A linear compressor that quits in year seven is still a covered part, but only a diagnosis proves the compressor failed rather than a fan or a board. Laundry works the same way. A washer that won’t spin may have a bad direct drive motor, which is covered, or a bad control board, which isn’t once year one ends. If your LG sits inside one of these terms, mention it when you call.

OE, IE or LE on an LG washer

LG front-loaders and top-loaders share most of their codes. This is how LG’s list defines them.

Washer control panel with a cycle dial and a lit display

Code LG’s meaning
OE Won’t drain, or drains slowly
IE Not enough water coming in, or none
UE, uB Unbalanced load
LE Motor overloaded and locked
dE, dE1, dE2 Door open or not locking
FE Overfilling
PE Water level sensor fault
tE Heating fault or bad thermistor
SUD Excess suds

For OE, LG blames a kinked drain hose or a plugged drain pump filter, and the drain pump is the next thing the tech checks. IE begins at the supply valves and inlet hoses and moves on to the water inlet valve. FE and PE both lead to the fill side, where an inlet valve may not be shutting off or the water level sensor may be reading wrong.

A musty smell from an LG front-loader usually comes from the door gasket. LG says lint and hair caught in the gasket hold water, detergent residue builds up around the drum, and a clogged drain pump filter leaves water standing. If the smell is still there after several Tub Clean cycles, LG says it needs service, and the tech checks the gasket, the filter and the drain.

LG links LE to overloading, cycles run back to back, or something like a coin wedged in the drum. If none of those explains a repeat LE, the tech tests the direct drive motor and its wiring, the washer part with LG’s ten-year term. Leaks, noise and spin trouble that come without a code are on the washer repair page.

LG dryer not heating, or flagging d90 or tE

LG calls these Flow Sense warnings. The dryer has measured its exhaust and found it about 80, 90 or 95 percent blocked. LG wants a vent hose with no crushed, kinked or dented spots, laid straight or in a gentle S curve, and it advises against drying with a badly restricted exhaust. Hold off on loads until the vent has been checked. The tech looks at the connection behind the dryer and the whole duct run, and if the air moves well, at the blower and the heat source.

tE1 points to the dryer’s thermistor, the sensor that reads the heat, and if it comes back after a power reset, the sensor or its wiring gets tested. tE2 is different: LG says it can show during steam cycles in cold weather, when the duct cools too fast, and LG’s first check is the flapper on the outside vent hood, which has to open fully.

A WashTower stacks the dryer over the washer as one unit, with the controls in the middle, and LG prints a separate code guide for it. Say it’s a WashTower, and mention a closet install, since the unit has to be pulled forward to get at the vent and the rear panels. About a quarter of the homes in Milpitas were built after 2010, and newer condos and townhomes like those are where stacked closet laundry turns up. Heat problems across every brand are covered under dryer repair.

LG dishwasher not draining: OE, IE or AE

LG dishwasher codes read like the washer’s, but they mean different things. OE says it isn’t draining, and LG’s first suspects are food packed in the filter, a blocked air gap or disposal, and a kinked drain hose. LG also wants the hose no longer than 12 feet, with its end 12 to 40 inches off the floor. IE means the tub didn’t fill to level within 10 minutes, so the supply valve, the water line and house pressure (LG asks for 20 to 120 psi) come first. AE means water has leaked inside the dishwasher, and on some models the overfill protection shows E1 and shuts the machine down. Leave the water valve closed on an AE until the leak is found. Drain and leak trouble on other brands is on the dishwasher repair page.

F9, F10 or HS on an LG range

LG range codes come close to naming the part. F9 is an oven that isn’t heating properly (the upper oven on a double-oven model). F1 or F2 flags the upper oven’s thermistor, the sensor that reads oven temperature. F10 is a fault in the upper oven’s door lock, F3 a touch pad key and F11 a communication fault between boards. HS isn’t a fault: it shows while the cooktop surface is hotter than 150°F. With an F9, the bake element and thermistor are tested before the control board. Range trouble on other makes is covered under oven, range and stove repair.

In February 2025, LG recalled electric ranges sold from 2015 through January 2025, because someone brushing past, or a pet, could switch on the front-mounted knobs. If yours is on the list, keep kids and pets clear of the knobs and read us the model number on the call.

An LG well out of warranty that needs a large part can go either way. The repair or replace guide lays out how to weigh the repair against a new machine.

Questions LG owners ask about coverage and codes

Does LG's warranty cover the replacement part as well?

Yes, for whatever remains of the original warranty or 90 days, whichever runs longer. LG's warranty papers also allow refurbished or remanufactured parts, so a covered replacement might not be brand new.

The LG came with the house and I have no receipt. When did the warranty start?

Ninety days after the manufacture date. That's how LG handles it without proof of purchase, which is common in a house or rental where the appliances were already in. Read us the model and serial number on the call.

My LG fridge is clicking and not cooling. Is it the linear compressor?

Not always. LG says a linear compressor can pop or tap for 30 to 90 seconds as it starts, and relays and the defrost control click as part of normal running. Compressor noise lasting over an hour, or loud enough to hear from another room, needs a repair, and so does a fridge that's still warm a day after a reset.

How do I reset an LG refrigerator?

LG's reset is to unplug it or switch off its breaker for 30 seconds. The compressor should start again, and the fridge should be cooling within 24 hours. If it isn't, LG treats it as a power or parts fault for a repair visit. Read any code on the door to us before the reset, since it may clear.

What is tCL on an LG washer?

It isn't a fault. tCL is LG's prompt to run the Tub Clean cycle. If a musty smell hangs on after a Tub Clean, the tech looks for standing water in the door gasket and the drain pump filter.

Can d80 on an LG gas dryer point to something other than the vent?

Yes. LG says that on gas models d80 can also mean a gas supply problem. The tech checks the vent run first, then tests the gas valve and igniter if the airflow is good.

Repair for other makes in the kitchen and laundry

LG dryer flagging d90 on every load?

On the visit the duct gets traced from the dryer to the outside wall, then the blower and heat get checked. The price is in writing before any part is ordered.

Call (669) 205-6920