San Jose Appliance Care books Bosch dishwasher repair in San Jose on every series Bosch sells, from the 100 up through the 800 and Benchmark. Bosch’s 24-inch compact laundry, its cooktops, slide-in ranges and wall ovens are on the same number. A tub that won’t empty points somewhere different from a code on the door edge, and both differ from a wash that stops partway through. Tell us the series, if it’s printed on the door, and whether some of the water went down. Bosch owners in Santa Clara and Sunnyvale call the same number.
E15 and water in the base of a Bosch
E15 means the safety switch has found water in the dishwasher’s base, and the leak protection has shut the machine down. Turn off the water to the dishwasher, then call. Don’t tip the machine to drain the base: the water came from somewhere, and that leak is the repair.
The tech traces where it started. The door seal, the pump seals and the hoses inside the cabinet are the usual sources, then the float switch that tripped. On a newer Bosch the same condition shows as E:30-00 or E:31-00, in the table below.
E:61-03 and the other newer Bosch dishwasher codes
Older Bosch models show short codes like E15, E24 and E25, and you’ll find those in the appliance error code library. Newer ones use a colon and a dash, and Bosch’s recent manuals spell out what they mean.
| Code | Bosch’s meaning |
|---|---|
| E:30-00, E:31-00 | The water protection system has tripped |
| E:34-00 | Water won’t stop coming in |
| E:32-00 | Water isn’t getting in; Bosch lists a bent hose, a shut valve, or a plugged screen in the supply or AquaStop line |
| E:92-40 | Filters are blocked |
| E:61-03 | The dishwasher can’t drain |
| E:61-02 | The drain pump is blocked |
| E:90-01 | Supply voltage is too low |
Act right away on the water protection codes. If E:30-00, E:31-00 or E:34-00 comes up, shut off the dishwasher’s water supply first and call after that. For anything missing from the table, read the code to us exactly as the display shows it.
Water sitting in a Bosch after the cycle ends
Bosch handles leftover water as a drain fault before anything else. The filter comes first, then the drain pump under it. Bosch also warns that broken glass can end up in the pump area, which is a good reason to let the tech handle that part. If the pump cover isn’t clicked all the way in, it throws its own code.
On older models the same complaint shows as E24, which Bosch ties to a blocked drain filter. On a fresh install, Bosch adds one more cause. The knockout plug in the garbage disposal’s dishwasher inlet never got punched out, so the water has nowhere to go.
A clean filter with water still sitting over it moves the search to the pump and then the hose downstream. On the call, say if the disposal is recent and whether the machine hums at the end of the cycle while nothing goes out. The dishwasher repair page covers drain trouble on other makes.
Bosch not cleaning, or food left on the dishes
The lower spray arm is the first suspect. Bosch’s Benchmark manual flags E:92-10 when that arm can’t turn, and the same manual lists blocked spray arm nozzles and filters that are dirty or not twisted into place behind food left on dishes. Rinsing dishes too well before loading can cause it too. The sensors read clean water and pick a lighter cycle, which isn’t enough for baked-on food.
If the spray arms turn freely and the filters are clean, the tech checks the circulation pump that feeds the arms and the water heating. Say whether the dishes come out cold, since that sends the search to the heater.
Bosch won’t start, or stops partway through
Bosch’s own list starts with the door. A door that isn’t fully closed stops the start, and so does an upper rack pressing on the inner door, or a rear panel pushed in by an outlet or hose holder behind the machine. With the door clearly latching, a dishwasher that still won’t start or cuts out mid-cycle points the tech to the door latch, its switch and the control.
San Jose’s hard water reaches inside a Bosch too. San Jose Water’s groundwater figures, on the dishwasher repair page, are well above the hardness Bosch says must be softened. On Benchmark models with a built-in water softening system, the factory setting is H:00, which leaves softening off. Bosch’s E:20-60 code means the heating element has calcified, and its manual blames a wrong hardness setting for stubborn white coating. Mention a new Bosch on hard water when you call.
E07 or E10 on a CrystalDry model
A dead fan motor is what Bosch ties to E07. E10 is the heater in the zeolite chamber, the mineral pack CrystalDry machines dry with, and some manuals print those faults as E2130 and E2120. A PureDry or AutoAir Bosch has no zeolite chamber at all, so the series decides what these two codes can mean.
Check the FD on the door plate for one more reason. Bosch recalled a group of dishwashers made or sold between 2008 and 2015 over a power cord that could run hot. A machine in that group shouldn’t be run until the fix is done, and the FD is the number we’ll ask you for.
Bosch warranty terms for year one and beyond
Bosch’s standard limited warranty lasts 365 days from the original purchase and covers the whole appliance, parts and labor. A few dishwasher parts keep parts-only coverage longer.
| Period | What’s covered |
|---|---|
| First 365 days | Parts and labor on the entire appliance, every Bosch category |
| Years 2 to 5 | Dishwasher electronics (the microprocessor or circuit board) and dish racks, not their components, parts only |
| Lifetime | Rust-through on the dishwasher’s inner tub liner and stainless door, parts only |
Bosch cooking, ventilation and microwave products stop at the one-year term. If your Bosch is under a year old, or a dishwasher board has failed inside five years, bring it up when you call. Past those terms, you only pay for work you agreed to.
Compact Bosch washer reading E18, E17 or E:00-23
Every Bosch washer and dryer sold here is a 24-inch compact, with 500 and 800 Series washers next to condensation and heat pump dryers. These washer codes come straight from Bosch’s owner material:
- E18 or F18: the drain hose is blocked or kinked.
- E17 or F17: the inlet filters are clogged, or water pressure is low.
- E:00-23: water has gotten into the base of the washer. Bosch says to turn off the water tap and call.
Compact washer leaks, spin faults and drain problems are on the washer repair page.
Bosch compact dryer taking too long to dry
Bosch’s condensation and heat pump compact dryers don’t vent outside. The moisture comes out through a condenser instead. On a condensation model, Bosch says to clean that condenser every month, and a clogged one stretches drying times and leaves loads damp. Heat pump models rinse their own condenser, but only with the blue filter seated in the tank kit; without it, lint reaches the condenser and can clog it. Bosch also has owners wipe the moisture sensor, since residue on it ends cycles early.
When the lint filter, condenser and sensor are clean and loads still come out wet, the tech checks the heating side and the pump that empties the water tank.
Bosch B36 French-door fridge running warm
On a Bosch B36 French-door refrigerator, Bosch’s own first checks are the temperature setting, which gets bumped, and the vents inside, which food can block. A door seal that frosts at the edge lets warm air in. Past those, the tech checks the fans, the defrost system and the sealed system. Warm-fridge symptoms on any make are on the refrigerator and freezer repair page.
A Bosch cooktop or wall oven code with no broken part
A lot of what shows on a Bosch cooktop or range is a warning about conditions, with the hardware intact. Demo mode reads dE. Overheated electronics that need a rest show F2 or F4, and F5 is a hot pot parked too near the touch controls. U400 and E9000 are both about incorrect voltage at the supply.
A Bosch wall oven showing E11 has touch keys that won’t react, and condensation can be behind it. Most other oven codes that read as E and a number are ones Bosch says need a service visit. Let us know if the code returns after everything has cooled. Cooktop problems shared across brands are on the cooktop and microwave repair page.
