A repair price comes down mostly to the part that failed and the labor it takes to fit it. San Jose Appliance Care books registered, insured techs for refrigerator, washer, dryer, dishwasher, oven and range repair in San Jose and the South Bay cities around it. This guide sets the national repair medians from Consumer Reports member surveys next to federal wage data for the San Jose area, so you can see roughly where a local repair should land.
Median repair prices by appliance
Consumer Reports asks its members what they paid for repairs that went ahead. The washer and dryer figures come from its 2024 survey and the range figures from 2021. A median means half of those jobs came in lower and half came in higher, which makes it a fair yardstick even though it can’t price your fault.
| Appliance | Median repair cost (Consumer Reports) |
|---|---|
| Refrigerator, for not cooling, the ice maker, the dispenser and other common faults | about $150 to $240 |
| Refrigerator compressor | $562 |
| Washer, top-load with agitator | $123 to $175 |
| Washer, high-efficiency top-load | $142 to $213 |
| Washer, front-load | $158 to $214 |
| Dryer, gas or electric, depending on what it cost new | $116 to $200 |
| Dishwasher | about $142 |
| Range | $206 |
| Pro-style range | $290 |
| Wall oven | $264 |
What a table like this can’t show is which part gave out, and that decides most of the price. A fridge that won’t cool might need an evaporator fan, a defrost heater or a control board. “Dryer repair” covers a thermal fuse and a whole new drum alike, and those two jobs aren’t priced anywhere near each other. The purchase price of the machine shifts the figure too: the dryer medians climb from budget models up to dryers that sold for more than $900.
The surveys leave out cooktops, built-in microwaves and garbage disposals. For cooktop and microwave repair or garbage disposal repair, the price still follows the part and how hard it is to reach.
What the first visit covers
The first visit is where the fault gets found. The tech confirms the symptom, takes off the panels needed to reach the likely parts, and tests them with a meter instead of guessing from the symptom. Most of the time spent on a first visit goes into that diagnosis, which is why the time to reach the part matters as much as the part itself. When the fault is pinned down, you get the price for the repair in writing, and the work only goes ahead once you say yes.
What drives the price, appliance by appliance
Refrigerators and freezers
Fans, defrost heaters, thermistors and water valves are the low end of a fridge repair. Control boards sit in the middle. Anything inside the sealed system is the high end, because the refrigerant has to be recovered and the system brazed, evacuated and recharged.
Washers and dryers
Lid switches, door locks, belts and thermal fuses are the smaller jobs. Drain pumps, inlet valves and heating elements are mid-range. Washer bearings and transmissions cost the most, since the tub usually comes apart to reach them. The table shows front-loaders running a little higher than top-loaders at the median.
Dishwashers
Door gaskets, latches and drain hoses are quick. Wash and drain pumps, heaters and control boards cost more, and a panel-ready unit adds the time to pull it out of its opening and refit the panel.
Ranges, ovens and cooktops
Igniters, bake elements and temperature sensors are the common oven repairs and sit at the lower end. Control boards and gas valves cost more. On a cooktop, a spark module or an infinite switch is a small part, while an induction power board or a cracked glass top is a large one.
Microwaves and disposals
On an over-the-range microwave, the door switches and the light or fan parts are small jobs, while the magnetron, the high-voltage parts and the control board cost more. The price of getting the unit off the wall and back up adds to any of them. A disposal that’s jammed or has a tripped reset is a short job. A cracked housing or a worn-out motor usually means a new unit, priced with the install.
What makes a job take longer
Some jobs take longer than others, and time is labor. A part that isn’t on the truck means ordering it and coming back to fit it. A built-in or stacked install takes longer to open up and close back down. A fault that only shows under load, like a fridge that warms overnight, can take a second check after a part goes in. The written price covers the whole job, including a return trip for an ordered part, before you agree to it.
Why San Jose labor costs more than the national rate
The Bureau of Labor Statistics tracks pay for home appliance repairers across the country and in each metro area. In its May 2025 survey, the San Jose-Sunnyvale-Santa Clara metro comes in well above the U.S. figures.
| Home appliance repairers, May 2025 | United States | San Jose metro |
|---|---|---|
| Mean hourly wage | $26.94 | $32.41 |
| Median hourly wage | $24.51 | $29.61 |
Both measures point the same way. A wage isn’t a repair price, since the hourly rate on a job also has to cover the van, fuel, insurance, a stock of parts and the drive between calls. The direction holds anyway, so a San Jose repair is more likely to sit in the top half of the national medians than near the bottom.
A fridge compressor costs more than double any other fridge job
A refrigerator’s sealed system is the compressor, the condenser and the evaporator, plus the tubing that moves refrigerant between them. Getting into it means recovering the refrigerant, brazing in the new part and recharging the system. That labor is why the $562 compressor median sits so far above every other fridge line in the table.

Warranty coverage can change that number completely. Sub-Zero, LG and Samsung each cover the sealed system or the compressor for longer than the rest of the refrigerator. If yours could still be inside that window, bring it up when you call.
High-end brands, built-ins and parts on order
A few things push a repair toward the top of the range, and they often show up together in the same kitchen.
The brand. Parts for built-in and pro-style brands cost more than parts for a mainstream freestanding model. You can see it in the table, where the pro-style range median of $290 sits above the $206 for ranges overall.
Built-in access. A built-in refrigerator, a panel-ready dishwasher or a wall oven takes longer to get out of the cabinetry and back in than a freestanding unit, and that time is labor. Say it’s built in when you call so the visit is planned around getting at it.

A big price on a built-in is often still the better spend, because whatever replaces it has to fit an exact cabinet opening. The repair or replace guide runs through that comparison.
A part on order. Brand-specific parts for built-ins often have to be ordered in, which adds the return trip described above.
From a median to a written price for your repair
A diagnosis is the only thing that turns these ranges into your number. On the call, read us the brand and the model number, printed on a label inside the door or on the back. Say whether the appliance is built in, and describe the symptom in a sentence or two. If the display is showing a code, read that out as well. The appliance error code library lists what each maker’s codes point to.
Once the fault is found, you see the number in writing and decide. You only pay for work you agreed to.
